Oil Line Fittings Kit for Gearbox – Ferrari 330 P4 1:8

Detailing kit for the oil line fittings of the Ferrari 330 P4 gearbox assembly in 1:8 scale, designed to enhance the realism of the connections and mechanical components of the model.

The fittings reproduce the different connection geometries, while the smooth photo-etched clamps provide an accurate finishing detail.

Kit Contents

• 1 × Front straight fitting

• 1 × Rear straight fitting

• 1 × Upper 110° angled fitting

• 3 × Smooth photo-etched clamps

The kit is supplied pre-painted and ready for installation.

Assembly Instructions

Step-by-step assembly images are available in the product gallery.

For easier installation, we recommend preparing the photo-etched clamps in advance, with their ends already connected, and sliding them directly onto the oil lines.

Front and Upper Fittings

Both fittings are installed using a press-fit connection.

Rear Fitting

To install the rear fitting:

1. Remove the original pin from the gearbox control housing.

2. Drill a 1.45 mm diameter hole using a 1.5 mm drill bit.

3. Install the rear fitting.

Important Information

• Scale: 1:8

• Model: Ferrari 330 P4

• Finish: Pre-painted components

• Oil lines and gearbox assembly: Not included

• 1.5 mm drill bit: Not included

Note: Before installation, refer to the product gallery images to identify the correct positioning of each fitting.